Terminal Identification
1-5
6-8
9-16
17
18-19
20-24
25-31
32-33
34-35
36-39
40-48
49-51
52-59
60-63
64-69
70-73
73-76
77-80
80
81-84
85-88
Notes: For test table:
^ The socket designations of the VAG 1598 test box are identical to the contact designations of the ABS control module (w/EDL) -J104- in the wiring diagram. Incorrect test procedures can cause damage to the system: do not make connections between any contacts other than those listed in the table
^ The specified values refer to the readings obtained on VAG 1526 tester and are not necessarily applicable for other test units.
^ If the readings obtained do not match the specifications, carry out the malfunction repair measures in the right-hand part of the table.
^ If the specified values are achieved, also check wiring for intermittent loose contacts and short circuit to positive and Ground (GND). This applies especially to sporadic malfunctions.
^ Use VAG 1594 test leads for checking continuity (bridging leads).
^ If the measured figures only differ slightly from the specifications, clean the sockets and plugs of the testers and test leads (with contact spray G 000 700 04) and repeat the check. Before replacing components, check wiring and connections again, particularly if the specification calls for a resistance reading of less than 10 Ohms.