Front Wheel Drive
Sender For Fuel Gauge -G, Removing and Installing
Removing
- Remove closing flange fuel delivery module removing.
- Carefully remove closing flange together with fuel pump module and set aside.
- Remove harness connector for sender for fuel gauge on inside of closing connector.
- Remove sender from accumulator housing while pressing down on release tabs (lower) -arrow-.
NOTE: To make the illustration clearer, the accumulator housing is shown without the fuel tank.
Installing
Installation is the reverse of removal, however note the following:
- Install sender for fuel gauge into guide at outside of accumulator and push in to stop.
- Install closing flange together with fuel pump module and observe notes concerning reconnecting battery.