Transmission Selector Mechanism, Disassembling and Assembling

Transmission selector mechanism, disassembling and assembling





Special tools and workshop equipment required
^ VW 439 Guide pin
^ VW 401 Thrust plate
^ VW 408 A Press tool
^ VW 447 i Thrust plate
^ 3129 Fitting tool





Special tools and workshop equipment required
^ -1- Kukko 21/3 internal puller





1. Selector shaft
2. Stop ring
3. Ball sleeve
^ Removing, Refer to Fig. 1
^ Pressing in, Refer to Fig 2
4. Selector mechanism cover
5. Switch for reverse lights - 20 Nm
^ Lightly coat lug with MoS2 grease
6. Cap
^ For transmission breather
7. Relay lever
^ Installation position, Refer to Shift Lever, MT, Service and Repair
8. Bushing
9. Oil seal
^ Lever out with screwdriver
^ Installing, Refer to Fig. 3
10. Circlip
11. Hexagon nut, 25 Nm
^ Self - locking
^ Always replace
12. Gear selector lever
^ Install so that the master spline aligns with selector shaft
^ Can be replaced with the selector mechanism installed
^ Installation position, Refer to Shift Lever, MT, Service and Repair
13. Cover plate





Fig. 1 Removing ball sleeve from selector mechanism cover
- Before pulling out ball sleeve, destroy plastic cage and remove balls. A - Internal puller, e.g. Kukko 21/3, 18.5-23.5 mm





Fig. 2 Knocking ball sleeve into selector mechanism cover





Fig. 3 Installing oil seal onto stop