With Generic Scan Tool

Readiness Code, Generating

Test requirements:
- Fuses for engine electronics OK
- Ground (GND) connections at engine and transmission OK
- Battery voltage at least 12.7 V
- Exhaust system free of leaks.
- Vehicles with automatic transmission: Selector lever in position "P" or "N".
- Electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.
- No DTCs in DTC memory; check DTC memory "Mode 3: Check DTC memory".
- Throttle valve angle 12.0 to 16.0 % "Mode 1: Check measuring values "; "PID 17: Throttle valve position (absolute).

Let vehicle cool off with the ignition switched off until the following conditions are met:
- Intake air temperature 10 to 50 degree C "Mode 1: Check measuring values "; "PID 15: Intake air temperature".
- Coolant temperature approximately Intake Air Temperature (10 to 50 degree C) "Mode 1: Check measuring values "; "PID 05: Coolant temperature.

Procedure

CAUTION: To reduce the risk of accident during road tests, always observe safety precautions. Safety Precautions

- Connect diagnostic tester.
- Start engine and let run at idle for at least 15 minutes.
- Perform a 15 minute road test in the highest gear or in the highest driving mode on a level driving surface.

The following operating conditions must be met during this road test:
- Engine speed 1800 to 2200 RPM "Mode 1: Check measuring values "; "PID 12: Engine rotations per minute".
- Vehicle speed constant 90 km/h "Mode 1: Check measuring values "; "PID 13: Vehicle speed".

- Read readiness code.