Front Final Drive, Servicing

Front final drive, servicing
^ Transmission installed





Notes:
^ General repair notes.
^ Rules of cleanliness for working on automatic transmissions.

1 - Seal
^ Between final drive and transmission housing
^ Always replace
2 - Adjustment shim
^ Behind tapered roller bearing outer race
3 - Tapered roller bearing outer race
4 - Locking screw - 30 Nm
^ With seal
^ Always replace
5 - Bolt - 23 Nm
6 - Right drive flange
7 - Right drive flange seal
^ Always replace
8 - Bolt - 23 Nm
^ Observe tightening sequence
9 - Cover for final drive
10 - Adjustment shim
^ Behind tapered roller bearing outer race
11 - Tapered roller bearing outer race
12 - O-ring
^ Always replace
13 - Differential
14 - Bolt - 23 Nm
^ Observe tightening sequence
15 -Cover for front final drive
^ Front wheel drive version shown
^ All Wheel Drive (AWD) version item no. 31
16 - Bushing
17 - Gasket
^ Always replace
18 - Spring dowel sleeve
19 - Lever
^ For shift rod
20 - Seal
^ For shift rod
^ Always replace
21 - Bolt - 23 Nm
22 - Left drive flange seal
^ Always replace
23 - Drive gear
^ For speedometer Vehicle Speed Sensor (VSS) -G22
^ Installation position
24 - Left drive flange Removing and installing
25 - Mounting bracket for drive flange
26 -Grooved ball bearing for drive flange
^ Always replace
27 - Snap ring
28 - O-ring
^ Square cross section
^ Remove and install left drive flange to replace