Adaptation (Function 10)

Central Locking System On Board Diagnostic (OBD)

Adaptation (Function 10)

Requirements:
- Connect VAG 1551 Scan Tool (ST).
- Switch on ignition.

Implementing function "10 - Adaptation"

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons -1- and -0- to select "Adaptation" function.
- Confirm entry with -Q- button.

Indicated on display:

Rapid data transfer Q
10 -Adaptation

- Confirm entry with -Q- button.

Indicated on display:

Adaptation
Enter channel number XX

- Enter desired adaptation channel.
- Confirm entry with -Q- button.

NOTE: After changing adaptation value/following termination of an adaptation channel, function "10 - Adaptation" must be implemented again to select a different adaptation channel.

Matching of remote control keys by way of adaptation function
- Switch on ignition.

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons -1- and -0- to select "Adaptation" function.

Indicated on display:

Rapid data transfer Q
10 -Adaptation

- Confirm entry with -Q- button.

Indicated on display:

Adaptation
Enter channel number XX

- Press buttons -2- and -1- (to select "Channel 21".

NOTE:
- Wrong entries can be corrected by pressing C key.
- Confirm entry with -Q- button.

Indicated on display:

Channel 21 Adaptation 0 ->
Key Setting Greater than -1 3- Less than

Top line shows selected channel and memory position for key to be matched. Select desired memory position of key to be matched with button-1-and-3-(or on VAG 1552 with buttons (down arrow) and (up arrow)).

- Third memory position is selected in example.

Indicated on display:

Channel 21 Adaptation 3 ->
Key Setting Greater than -1 3- Less than

- Press remote control opening/closing button.

Indicated on display:

Channel 21 Adaptation 3 Q
Key Recognized

Display "Setting" switches to "Recognized" following recognition of remote control command.

- Confirm entry with -Q- button.

Indicated on display:

Channel 21 Adaptation 3 Q
Store altered value?

- Confirm entry with -Q- button.

Indicated on display:

Channel 21 Adaptation 3 ->
Altered value stored

- Press -> button.

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -6- to select "End Output" function.
- Switch off ignition and remove ignition key.
- Check function of newly matched remote control button.

NOTE:
- Successful adaptation can be established by way of Read Measuring Value Block function (function 08), display group number 007.
- Make sure care is taken that new keys are always matched to vacant memory positions. If use is made of a memory position already occupied, the matched remote control key already allocated to this memory position will no longer function.
- A maximum of four keys can be matched.