Seat Cushion

Seat cushion, removing and installing







1 - Seat cushion
Removing
- Move seat fully up.
- Remove seat.
- Remove seat cushion extension, front cover panel and guide sleeves.
- Remove mounting trim pieces.
- Remove spring cover.
- Detach electrical cover -2- under seat.
- If installed, disconnect seat cushion wiring (seat heater, seat occupied sensor).
- Push up front of seat cushion -1-.
- Remove seat cushion -1- forward and out.


NOTE: Both seat springs and their related rubber buffers located in the rear between seat cushion and backrest fall out by themselves.


Installing
- Make sure that rubber buffers -3- are correctly located in the mounts on the backrest.
- Install springs -4- in seat cushion.
- Insert electrical cover -2- between backrest and seat frame.
- Install seat cushion -1- so that springs -4- sit on rubber buffers -3- at backrest.
- Push seat cushion -1- toward rear.
- Push down on front of seat cushion -1-.
- If necessary, attach wiring in seat cushion.
- Install electrical cover beneath seat.
2 - Electrical cover
3 - Rubber buffers (2x)
4 - Springs (2x)