Cellular Phone: Service and Repair

Car Telephone / Mobile Phone Lift Mechanism In Center Armrest, Removing And Installing







1 - Center armrest

NOTE: For clarity, illustration shows components removed from vehicle and without cover.

2 - Lift mechanism for car telephone / mobile phone

Removing
- Release lift mechanism - 2 -.
- Warm bolts - 5 - using a soldering iron until smoke rises and then loosen the bolts with a jolt.
- Remove bolts - 5 - (4x).

Installing
- Always use new bolts.

3 - Carrier for mobile phone

Removing
- Remove center armrest.
- Remove right-hand hinge trim.
- Release wire -6- from mounts - 7 - and - 8 -






- Pull wire - 6 - through to the inside together with connector - 9 -.

Installing
- Make sure that wire - 6 - is not trapped.

4 - Release catch for lift mechanism

Removing
- Use a screwdriver to pry out release catch - 4 - at the top.
- Press out release catch - 4 - at the bottom.

Installing
- Insert at the bottom first.

5 - Bolts (4x)
- Before removing, warm bolts - 5 - using a soldering iron until smoke rises and then loosen the bolts with a jolt.
- Always replace.
- Before installing new bolts, clean out threads in threaded inserts (re-tap).
- Tightening torque: 2 Nm (18 in.lb)

6 - Wire
7 - Mount
8 - Mount
9 - Connector

Side hinge trim, removing







- Remove rubber insert - 2 -.
When installing, note position of slot - 4 -.
- Pry off hinge trim - 1 - carefully using a screwdriver - 3 -.

Wire and connector for telephone, removing







- Release wire - 2 - from mounts - 3 - and - 4 -.
- Using a screwdriver, pry connector - 1 - from underneath in direction of arrow.
- When installing, insert retainer lugs - 5 - first.