Seat, Removing and Installing

Seat, Removing And Installing







NOTE:
- The removal and installation procedures may have to be modified slightly depending on optional equipment.
- On vehicles with power seat with memory, run the seat all the way to the rear and to the top height setting before disconnecting battery.
- Obtain radio code before disconnecting battery.

See Caution for disconnecting Telematics battery

CAUTION: Disconnect battery Ground (GND) strap before removing seat.

Removing
- Push seat forward.
- Remove rear cover on front seat rail (outer side)
- Remove rear cover on front seat rail (inner side)







- Push back seat.
- Remove cap - 1 -
- Remove cap - 1 - (power seat with memory)
- Remove bolts - 2 - (2x) and unclip seat at clip - 3 -.
- Connect VAS 5094 airbag adapter

1 - Cover
2 - Bolts
- Tightening torque: 23 Nm (17 ft lb)
- Self-locking
- Always replace
- Threaded holes for bolts must always be cleaned (e.g. with a thread tap)
3 - Clip
4 - Rear rollers
5 - Front slides
- Lubricate front slides - 5 - with multipurpose grease if seat does not slide back and forward smoothly.