Pinout Values and Diagnostic Parameters

Read Measuring Value Block (function 08)
- Initiate output Diagnostic Test Mode of instrument cluster, Initiating

Display on VAS5051:

- Select diagnostic function "08 - read measured value block" in selection -1-.

Display on VAS5051:

1 - Enter display group Max. input value = 255
- Enter desired display group number in button field -2-.
- Press -Q- button to confirm input.

Display on VAS5051:

1 - Display group X
2 - Display field 1
Display field 2
Display field 3
Display field 4

NOTE:
- If no display follows, a display field is not assigned.
- To switch to a different display group, proceed as follows:

Display group VAS5051 tester
higher Press s button.
Lower Press t button.

- Press "08 - Erase DTC Memory" to end function <- button.

Display group overview

Display group number Indicated on display
001 1 = Road speed km/h
2 = Engine speed (RPM)
3 = Oil pressure 2 < min
4 = Time h

002 1 = Trip odometer
2 = Fuel gauge 1
3 = Tank sensor Ohm
4 = Outside air temperature

003 1 = Engine coolant temperature ° C

010 1 = Channel 30
2 = Adaptation tank sensor
3 = Channel 9
4 = odometer mi

011 1 = Channel 4
2 = Language version
3 = Channel 3
4 = Consumption display

012 1 = Channel 40
2 = odometer since service mi
3 = Channel 41
4 = Time since service

013 1 = Channel 42
2 = Minimum value mi
3 = Channel 43
4 = Maximum value mi

014 1 = Channel 44
2 = Max. time interval
3 = Unassigned
4 = Unassigned

015 1 = Channel 45
2 = Oil quality
3 = Channel 46
4 = Total consumption quantity

050 1 = odometer mi
2 = Engine speed 1/RPM
3 = Oil temperature ° C
4 = Engine coolant temperature ° C

125 1 = Engine
2 = Transmission
3 = ABS
4 = ADR

126 1 =A/C

130 1 = Tire pressure
2 = Auxiliary heater
3 = Unassigned
4 = Parking assistance

140 1 = Radio
2 = Telephone
3 = Navigation
4 = Telematic (Tele-data-processing)

NOTE:
- If the instrument cluster is replaced, the data from display groups 010 to 015 must be printed out.
- Measuring value blocks 125 and 126 indicate the components that are part of the powertrain CAN-bus.
- Measuring value block 130 indicates the participants in the comfort system CAN-bus.
- Measuring value block 140 indicates the participants in the information CAN-bus.
- Display will always indicate the actual values obtained from senders and sensors. The values which appear on the instrument cluster are filtered and may be different.
- If the actual coolant temperature is between 80 °C and 100 °C, the instrument cluster always displays 90 °C.

Measuring value block 001