Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2004 >> S6 V8-4.2L (BBD) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Throttle Position Sensor >> Service and Repair >> Accelerator Pedal Module W/TP Sensors, Removing and Installing
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Accelerator Pedal Module W/TP Sensors, Removing and Installing



Accelerator Pedal Module With Throttle Position (TP) Sensors, Removing And Installing

- Remove driver-side storage compartment.
- Disconnect 6-pin harness connector.
- Remove threaded connections (3x).







- Remove accelerator pedal module (arrow).

Installing
Installation is the reverse of removal, noting the following:
- In a vehicle with automatic transmission, the kickdown function must be adapted when accelerator pedal module is replaced: To do so, switch on ignition and press accelerator pedal all the way down past the kickdown point and hold in position for at least 20 seconds.
- Switch ignition off.
- Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on again

Tightening torque

Component Nm
Accelerator pedal module 9
to pedal mount
pro multis · About Operation CHARM