Display Group 007

Display Group "007"

Air Flow Flap Motor V71

Display Field 1 - 4:

- The following air conditioner operating statuses (and all intermediate settings) can be selected via the levers installed to the flaps depending on the position of the control motor:
- Air flow/fresh-air flaps closed and recirculated-air flap open = recirculated-air mode.
- Air flow/fresh-air flaps open and recirculated-air flap closed = fresh-air mode.
- Air flow/fresh-air flaps partially closed and recirculated-air flap closed.

NOTE:
- With the vehicle stationary, the "air flow mode" setting is only attained during Output Diagnostic Test Mode (DTM) diagnosis.
- This control motor is used to activate the air flow/fresh-air flaps.
- This control motor is not installed on right-hand drive vehicles and this display group can therefore be ignored. On right-hand drive vehicles, the fresh-air flaps are moved by the Recirculation Flap Motor V113.
- The position of the air flow/fresh-air flaps is program-controlled in air flow mode. The flaps are closed as of approx. 80 km/h depending on vehicle speed, Fresh Air Blower speed, the selected and actually measured temperatures and the mode selected at the operating and display module, Climatronic Control Module J255. The air flow/fresh-air flaps are however not completely closed in air flow mode (they always remain open far enough to maintain the necessary air throughput).
- The notes on display group "003" also apply to this display group and should be observed if necessary.