Electrical Harness Connectors, Disconnecting

Electrical harness connectors, disconnecting







1 - Connector point cover

Removing
- Remove seat.
- Tip front seat - 2 - back.
- Remove coupling station cover - 1 - upward.
- Press in tab on connector for voltage supply - 5 - on tunnel side and disconnect connector for voltage supply.
- Press in tab on connector for heated seat - 4 - on tunnel side and disconnect connector for heated seat.
For vehicles with seatbelt fasten sensor:
- Press in tab on connector for seatbelt fasten sensor - 3 - on tunnel side and disconnect connector for seatbelt fasten sensor.

Installing
Installation is reverse of removal.
2 - Front seat
3 - Belt buckle sensor connector (black)
- Depending on version
4 - Seat heating connector (green)
5 - Current supply connector (red)
6 - Connector housing with terminal resistance for side airbag
- Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance.