Cover and Upholstery For Seat Pan, Removing and Installing (Standard Seat)

Cover And Upholstery For Seat Pan, Removing And Installing (standard Seat)

Separating Cover And Upholstery From Seat Pan







1 - Cover and upholstery

- Removal:
- Remove seat: Vehicles until 10.04, vehicles from 11.04.
- Remove side trim on sill side.
- Remove side trim on tunnel side.
- Remove the backrest.
- Remove bolts - 3 - (2x).
- Remove bracket - 2 -.
- Disconnect connector for seat heater - 7 -.
- Remove clip - 4 -.
- Pry out grip channels - 5 - all around.
- Disengage tab - 6 -.
- Remove cover and upholstery - 1 -.

- Installing:
Installation is reverse of removal.
- For vehicles with LATCH "Lower Anchor and Tethers for CHildren" bracket and new cover - 1 - , cover must be cut in at LATCH "Lower Anchor and Tethers for CHildren" bracket.
2 - Support
3 - Screws, (2x)
4 - Clip
5 - Peripheral fastening strips
6 - Tab
7 - Seat heating connector

Separating cover from upholstery







1 - Cover

- Removal:
- Pry out grip channels - 3 - from plastic clips - 2 - using a screwdriver.
- Remove cover - 1 -.
- For vehicles with LATCH "Lower Anchor and Tethers for CHildren" bracket and new cover - 1 - , cover must be cut in at LATCH "Lower Anchor and Tethers for CHildren" bracket.

- Installing:
Installation is reverse of removal. Observe the following when doing so:
- Replaced damaged plastic clips.
- Press in first the plastic clips of transverse beam.
2 - Plastic clips
- Replace if damaged
3 - Fastening strips