Seating Area Cover and Upholstery, Removing and Installing (Standard Seat)

Seating Area Cover And Upholstery, Removing And Installing (standard Seat)







1 - Cover

- Removal:
- Remove seat: Vehicles until 10.04 vehicles from 11.04.
- Remove backrest: Vehicles until 10.04 vehicles from 11.04.
- Unclip connector for heated seat - 2 - from bracket.
- Pry out plastic strips - 3 - all around using a screwdriver.
- Install cover - 1 -.
- Pry out grip channels - 4 - from plastic clips - 5 - using a screwdriver.
- Remove cover - 1 - upward.
- Remove upholstery - 6 -.

- Installing:
Installation is reverse of removal. Observe the following when doing so:
- Damaged plastic clamps - 5 - must be replaced.
- For vehicles with LATCH "Lower Anchor and Tethers for CHildren" bracket and new cover - 1 -, cover must be cut in at LATCH "Lower Anchor and Tethers for CHildren" bracket.

2 - Seat heating connector
3 - Plastic strips all around
4 - Fastening strips
5 - Plastic clips
- Replace damaged plastic clips
6 - Upholstery
7 - Seat heating
8 - Seat pan

Cover for LATCH "Lower Anchor and Tethers for CHildren" bracket, cutting







Cut into new cover on left and right sides at a length of approx. 60 mm.