Front Final Drive Assembly Overview

Front Final Drive Assembly Overview

General repair notes [Repair Information] .
Observe cleanliness rules when working on automatic transmissions [Cleanliness Working Conditions] .






1. Shaft seal
Between final drive and transmission housing
Replace, refer to [Final Drive/Transmission Housing Shaft Seal, Replacing]

2. Adjustment shim
Behind taper roller bearing outer race

3. Taper roller bearing outer race

4. Oil seal
Cannot be replaced separately

5. Sealing plug, 35 Nm
Replace

6. Bolt, 23 Nm
7. Right drive flange

8. Shaft seal
For right flange shaft
Replace, refer to [Right Flange Shaft Seal]

9. Bolt, 23 Nm
Observe tightening sequence, refer to [Final Drive Cover O-ring]

10. Cover for final drive

11. Adjustment shim
Behind taper roller bearing outer race

12. Taper roller bearing outer race

13. O-ring
Replace, refer to [Final Drive Cover O-rin ]

14. Differential

15. Bolt, 23 Nm
Observe tightening sequence [Tighten the front final drive intermediate flange in 2 steps:]

16. Front final drive cover
Shown here: front wheel drive version
AWD version, refer to Transfer Case

17. Alignment bushing

18. Gasket
Replace, refer to [Front Final Drive Gasket, Replacing]

19. Spring pin

20. Lever
For selector shaft

21. Shaft seal
For selector shaft
Replace, refer to [Selector Shaft Seal]

22. Bolt, 23 Nm

23. Shaft seal
For left flange shaft
Replace, refer to [Left Flange Shaft Seal and Grooved Ball Bearing]

24. Drive gear
For Speedometer Vehicle Speed Sensor (VSS) (G22)
Location [Mount the transmission with the : place the on the flange shaft]
Not installed on all versions
Transmission with v (G22), refer to [Transmission, All Wheel Drive, Code Letters, Assembly Allocation, Gear Ratios, Equipment]

25. Flange shaft, left
Removing and installing, refer to [Left Flange Shaft Seal and Grooved Ball Bearing]

26. Mounting bracket for flange shaft

27. Grooved ball bearing for flange shaft
Replace, refer to [Left Flange Shaft Seal and Grooved Ball Bearing]

28. Securing ring

29. O-ring
Rectangular cross-section
Remove and install left drive flange to replace, refer to [Left Flange Shaft Seal and Grooved Ball Bearing]