Fender
Fender
• Bolts and washers are micro-encapsulated and must be replaced after loosening or after removing the fender.
Up to Vehicle Identification Number (VIN) 400 000
1 - Fender
• Remove bumper => [ Front Bumper ] Front Bumper.
• Remove wheel housing liner.
• Remove end plate => Fig. => [ Removing and installing end plate ].
• Remove headlight: Headlamps=> Lighting and Horns Lighting and Horns
• Disconnect electrical connectors for the side blinkers.
• Remove bolts - 2 -
2 - Combination bolt
• 8 Nm
3 - Combination bolt
• 10 Nm
4 - Combination bolt
• 10 Nm
5 - Combination bolt
• 10 Nm
6 - Combination bolt
• 10 Nm
7 - Bracket
8 - Combination bolt
• 10 Nm
As of Vehicle Identification Number (VIN) 400 001
1 Brace for wheel housing liner
2 Combination bolt
• 10 Nm
3 Brace for fender
4 Combination bolt
• 10 Nm
5 Torx screw
• 10 Nm
6 Combination bolt
• 8 Nm
7 Wheel housing liner
• Removed
8 Combination bolt
• 10 Nm
9 Fender
• Remove bumper => [ Front Bumper ] Front Bumper.
• Remove wheel housing liner.
• Remove end plate => Fig. => [ Removing and installing end plate ].
• Remove headlight: Headlamps=> Lighting and Horns Lighting and Horns
• Disconnect electrical connectors for the side blinkers.
• Remove bolts - 5 -;- 6 - and - 8 - and remove fender.
Removing and installing end plate
- Front wheel removed.
- Wheel housing liner removed.
- Unscrew bolts - 1 - from expanding clip - 3 - and remove end plate - 2 - from fender - 4 -.
- Tightening torque 2 Nm