Blower Motor: Service and Repair

Fresh Air Blower Control Module J126 And Fresh Air Blower V2, Removing And Installing

Removing







- Remove glove compartment.
- Disconnect connector - A -.
- Remove lower "A-pillar" trim.
- Loosen cable ties - B -.







- Remove bolts - A -.
- Pull air conditioner slightly to rear.
- Carefully fold back floor covering.







- Press noise insulation mat aside until rear bolt - C - is accessible.
- Remove bolts - C -.
- Push noise insulation mat aside and pull Fresh Air Blower V2 - D - out of air conditioner.

NOTE:
- The Fresh Air Blower V2 contains the Fresh Air Blower Control Module J126 as an integral component which cannot be replaced separately.
- When installing, pay attention to correct positioning of Fresh Air Blower V2 in air conditioner.

Installing
Install in reverse order.