Drawer, Through 06.2006
Power Front Memory Seats
• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] Power Front Memory Seats Overview has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.
• The modular wiring routing has not been implemented for all countries.
• Check version of front seat and of vehicle and perform repairs accordingly.
• Note the two possible versions of the modular wiring routing, Modular Light or Modular => [ Modular Wiring Routing Versions ] Standard Front Seats Overview.
Seat Tilt Motor Adjustment
Special tools, testers and auxiliary items required
• Torque Wrench (V.A.G 1410)
• Engine and transmission holder (VAS 6095)
• Fixture for seat repair (VAS 6136)
1 Motor for seat inclination adjustment
• Removing
- Remove seat => [ Power Front Memory Seat ].
- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).
- Attach the front seat to the fixture for seat repair (VAS 6136).
- Remove bolts - 2 - (Qty. 4).
- Remove screw - 3 -.
- Remove connector - 4 -.
- Remove motor for seat tilt adjustment - 1 -.
• Installing
To install, perform the steps used in removal in reverse order.
2 Bolts
• 12 Nm
• Qty. 4
3 Bolt
• Tightening specification => [ Seat Pan Assembly Overview ] Power Front Memory Seats Overview
• Replace
• Threaded holes for screws must always be cleaned (for example, with thread cutter)
4 Connector
Drawer, through 06.2006
Special tools, testers and auxiliary items required
• Engine and transmission holder (VAS 6095)
• Fixture for seat repair (VAS 6136)
1 Drawer
• Removing
- Remove seat => [ Standard Front Seat ] Standard Front Seats.
- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).
- Attach the front seat to the fixture for seat repair (VAS 6136).
- Pull handle - 2 - and pull out drawer - 1 -.
- Insert a screwdriver with inserted bit into opening - 5 - and remove the bolt installed beneath.
- Remove bolts - 4 - (Qty. 2).
- Remove screw - 3 -.
- Remove drawer - 1 -.
• Installing
- To install, perform the steps used in removal in reverse order.
2 Handle
3 Bolt
4 Screws, (Qty. 2)
5 Opening