Accelerator Pedal Module, Version 2

Accelerator Pedal Module, Version 2

Removing





Proceed as follows:

- Remove the driver side lower instrument panel cover.

- Disconnect the electrical connector - 2 - by pressing the release - 1 - up - arrow -.

- Remove the bolt - 3 - and remove the accelerator pedal module downward.

Installing





• Assembly overview, refer to => [ Accelerator Pedal Module Version 2 Assembly Overview ] Accelerator Pedal Module Version 2 Assembly Overview.

• Tightening specifications, refer to => [ Fastener Tightening Specifications ] Fuel Supply System - Fastener Tightening Specifications.

Installation is performed in reverse order of removal, noting the following:

- Engage the accelerator pedal module - 4 - on the bottom of the pedal bracket - 1 -, insert the centering pin - 2 - and tighten the bolt - 3 -.

- Install the driver side lower instrument panel cover.

Vehicles with automatic transmission:

- Perform after the first kick-down adaptation in "Guided Functions".