Camshaft Adjustment Valve 1 N205, Removing and Installing

Camshaft Adjustment Valve 1 N205, removing and installing





Special tools, testers and auxiliary items required

^ Torque wrench V.A.G 1783
^ Torx bit assortment V.A.G 1766
^ Ratchet 1/4" VAS 6234
^ Spring-type clip pliers VAS 5024 A

Removing

Note:
^ Always replace gaskets and seals.





- Remove engine cover - arrows -.





- Separate electrical connector -1-.
- Remove wiring harness bracket - arrow -.

Note:
^ Do not pull out Camshaft Adjustment Valve 1 N205 at connector.





- Remove bolts - arrows - and remove Camshaft Adjustment Valve 1 N205 from housing.

Installing

Note:
^ Camshaft Adjustment Valve 1 N205 as well as housing must be free of dirt and contamination.
^ Remove new Camshaft Adjustment Valve 1 N205 from packaging only prior to installation.

CAUTION:
^ The Camshaft Adjustment Valve 1 N205 must not experience any hits or impacts.

- Coat sealing ring with engine oil.
- Carefully insert Camshaft Adjustment Valve 1 N205 into housing and press it in perpendicular to valve axle by hand as far as stop.
- Install bolts and tighten to 4 Nm with Torque Wrench V.A.G 1783, Ratchet Adapter 1/4 VAS 6234, TORX-Bit T20 and Bithalter from TORX bit set V.A.G 1766.

The rest of assembly is basically a reverse of disassembling sequence.

Torque specifications