Connectors, Disconnecting

Power Front Memory Seats

• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular => [ Modular Wiring Routing Versions ] Standard Front Seats Overview.

Connectors, Disconnecting

CAUTION!
• Observe safety precautions for work on airbags => [ Airbag Inspection ] .

• Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This can be done by touching door striker, for example.





1 Front seat

2 Belt buckle sensor connector (black)

3 Seat heating connector (green)

4 Current supply connector (red)

5 Airbag connector (orange)

6 Panel or cover

• For connector station

• Removing

- Tip front seat - 1 - back.

Vehicles without modular wiring routing through 07.2006

- Remove coupling station cover - 6 - upward.

Vehicles with modular wiring routing from 07.2006

- Remove connector station cover => [ Modular Wiring Routing with Corrugated Tube on Front Seat ] Standard Front Seats Overview.

Procedure for all vehicles

- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.

- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.

- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.

- For vehicles with seatbelt fasten sensor: Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.

- Connect airbag adapter => [ Airbag Adapter, Connecting ].

• Installing

To install, perform the steps used in removal in reverse order.

Vehicles with a DVD player





- Push the grommet - 3 - to the side.

- Disconnect and free up the electrical connectors - 1 - and - 2 - and free up the wiring harness.