Oil Pan Upper and Lower Sections, Oil Pump and Oil Cooler Assembly Overview
Oil Pan Upper and Lower Sections, Oil Pump and Oil Cooler Assembly Overview
1 9 Nm
• Depending on the version, bolt or nut
• Insert with locking compound.
2 Oil Level Thermal Sensor (G266)
• Removing and installing, refer to => [ Oil Level Thermal Sensor ] Service and Repair
3 Oil drain plug - 30 Nm
4 9 Nm
5 Lower oil baffle
6 16 Nm
• Fasten in diagonal sequence in steps
7 Oil pan (upper section)
• Removing and installing, refer to => [ Oil Pan, Upper Section ] Oil Pan, Upper Section
8 O-ring
• Replace
9 9 Nm
• Insert with locking compound.
10 Upper oil baffle
11 Gasket
• Replace
12 Gasket
• Replace
13 9 Nm
14 Engine oil cooler
• See note Lubrication System
• Removing and installing, refer to => [ Engine Oil Cooler ] Engine Oil Cooler
• With oil cooler by-pass valve
15 9 Nm
16 Driveshaft for oil pump
17 Spring
18 Bracket
19 9 Nm
20 Chain sprocket for oil pump
• Can only be placed onto driveshaft in one position
21 30 Nm plus an additional 90° turn
• Replace
• To loosen, counterhold on sprocket with Spanner Wrench (3212)pin wrench
22 O-ring
• Replace
23 O-rings
• Replace
24 20 Nm
25 Oil pump
• Do not disassemble
• With cold pressure relief valve 11 bar and pressure regulator valve 4.3 bar
• Removing and Installing
26 Bolt
Aluminum oil pan lower section:
• 9 Nm
• Fasten in diagonal sequence in steps
Metal oil pan lower section:
• Replace
• 5 Nm +90°
• Fasten in diagonal sequence in steps
27 Oil pan lower section
• Different versions
• Removing and installing, refer to => [ Oil Pan Lower Section ] Oil Pan Lower Section
28 Seal
• Replace