Rear Door
Rear Door
• After you have disconnected the electrical connections on the bottom of the A-pillar and B-pillar, you can lift the entire door completely out of the door hinges for various installation procedures.
• Adjustments must not be made after installation.
1 Door plate
- Pull bellows down from B-pillar.
- Disconnect electrical connectors on bottom of B-pillar.
- Loosen screw - 4 - on top of door hinge.
- Remove bottom combination screw - 9 - on bottom of door hinge.
- Remove cover cap from hinge bolt.
Protect painted surfaces on front or rear door from damage.
- Carefully lift door up and out of hinges.
2 Upper door hinge, upper part
• Not available separately.
• Remains installed on door side.
3 Upper door hinge, lower part
• Not available separately.
• Remains installed on B-pillar.
4 Locking screw
• 25 Nm
5 Cover
• Place on joint pins.
6 Securing spring
• Only installed on replacement part.
• Remove after installing new hinge.
7 Bottom door hinge, upper part
- Remove any tension between upper and lower parts on bottom of door hinges if necessary with screwdriver, for example.
• Not available separately.
• Remains installed on door side.
8 Bottom door hinge, lower part
• Not available separately.
• Remains installed on B-pillar.
9 Combination screw
• 32 Nm