Turn Signal Switch

Turn Signal Switch

Removing

- Remove the steering column switch module. Refer to => [ Steering Column Switch Module ] Steering Column Switch Module.

• Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.

- Carefully release catches - arrows -.





- Pull return spring with slip ring - 2 - with steering angle sensor (G85) - 1 - off from steering column switch module (SCSM).

- Remove bolts - arrows -.





- Pull steering column electronic systems control module (J527) - 2 - and windshield wiper intermittent mode switch (E22) - 3 - off from steering column switch module (SCSM).

- Disengage cruise control switch (E45) - 1 - from steering column switch module (SCSM).

- Remove bolt - 5 - and remove retaining bracket - 4 -.

Installing

• Tightening specification, refer to => [ Steering Column Switch Module Assembly Overview ] Steering Column Switch Module Assembly Overview.

Install in reverse order of removal, observing the following:

- Make sure all fasteners and electrical connectors are properly engaged.

- Install the steering column switch module. Refer to => [ Steering Column Switch Module ] Steering Column Switch Module.