Backrest Cover

Power Front Memory Seats

• From 07.2006, the usual wiring harness routing to connector station under front seat => [ Connectors, Disconnecting ] Power Front Memory Seats Overview has been replaced with modular wiring routing => [ Modular Wiring Routing, from 07.2006, Assembly Overview ] Standard Front Seats Overview.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular => [ Modular Wiring Routing Versions ] Standard Front Seats Overview.


4 Backrest cover

• Removing

- Disengage footwell cover - 8 - on underside of seat at tabs - 7 - (Qty. 4) from spring mat.

- Disengage retaining strip - 2 -.

- Loosen grip channels - 6 - (Qty. 2) from side panels => [ Footwell cover retaining strip, loosening ].

- Press against backrest panel - 4 - at position of arrow, in order to pry out wire clips - 3 - (Qty. 3).

- Disengage backrest cover - 4 - upward from brackets - 5 - (2x).

• Installing

To install, perform the steps used in removal in reverse order. When doing so, note the following:

- Replace clips - 3 - (Qty. 3).

- Slide footwell fastening strip into side trim bracket => [ Footwell cover retaining strip, loosening ].

5 Retainers (Qty. 2)

6 Fastening strips (Qty. 2)

7 Tabs (4x).

8 Footwell cover

Footwell cover retaining strip, loosening





- Disengage retaining strip - 1 - on footwell cover - 2 - from brackets - 4 - (Qty. 2) on side panel - 3 -.