Special Signal and Speaker Horn, Security
Special Signal and Speaker Horn, Security
Removing
• When installing, reinstall all cable ties that were loosened or cut during removal in the same locations.
- Switch off ignition and remove ignition key.
- Remove front bumper cover.
- Mark the wires - 4 - and - 5 -.
- Disconnect electrical connectors - 2 to 5 -.
- Remove the bumper.
- Remove bolts - arrows -.
- Remove the bracket together with the horn and the horn for the special signal/speaker - 1 - from the bumper.
- Remove bolts - arrows -.
- Remove the horns - 1 - and - 2 - for the special signal/speaker from the bracket - 3 -.
- Remove nut - 5 -.
- Disconnect the connector - 4 - and remove the horn from the bracket.
- Guide the wire from the bracket.
- To replace the horn, cut open the protective hose and remove the wire.
Installing
Install in reverse order.
Tightening Specifications