Exterior Mirror Turn Signal Lamps

Exterior Mirror Turn Signal Lamps

Special tools, testers and auxiliary items required

• Pry Lever - Rmv Outside Mirror (80 - 200)

• Protective gloves

Removing

CAUTION!
Risk of injury.

• Wear protective gloves.

• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.

- Press mirror glass - 1 - out of mirror adjusting unit - arrow - using (80 - 200).





- Disconnect the mirror heating electrical connectors - 2 - and - 3 - on the rear side of the mirror glass - 1 -.





- Unclip the electrical connector from the bracket - 5 -, if applicable.

- Disconnect the electrical connector - 4 -.

- Remove the bolts - 4 - and - 5 -.





- Release the retaining tabs - 3 - in direction of the - arrow A -.

- Release the retaining clip - 1 - and remove the exterior rearview mirror housing from the cover - 2 - - B arrows -.

- Press the mirror adjusting unit down and remove the exterior rearview mirror housing upward.





- Disconnect the electrical connector - 3 - for the exterior rearview mirror turn signal.

- Remove bolts - 1 - and - 4 -.

- Tilt the turn signal housing - 2 - out of the exterior rearview mirror housing - arrow -.

Installing

• Tightening Specifications, refer to => [ Exterior Rearview Mirror Turn Signals Assembly Overview ] Service and Repair.

Install in reverse order of removal, observing the following:

• The entire exterior mirror turn signal must be replaced if an LED is faulty.

- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing - 3 - - arrow A -.





- Tilt the turn signal bulb housing - 4 - into the exterior rearview mirror housing - arrow B -. The locking tab - 2 - must engage in the mount - 1 -.

- Attach mirror glass at mirror adjusting unit and press on mirror glass.

• Only press on the center of the mirror.