Left Exhaust System Tract
Left Exhaust System Tract
Removing
• Engine/transmission assembly removed and mounted on Scissor Lift Platform (VAS 6131 A).
• During installation, reinstall all heat insulation sleeves and heat shields at the same locations.
• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
- Remove bolts - 2 - and - 3 - and remove oil dipstick guide tube upward - arrow -.
- Loosen hose clamps - 1 - and - 4 - and remove left coolant pipe from coolant hoses.
- Remove electrical connector - 2 - for Heated Oxygen Sensor (HO2S) 3 (G285) (in front of catalytic converter) from bracket and disconnect it.
• Ignore - 1 -.
- Remove right oxygen sensor connection heat shield from transmission - arrows -.
- Remove the following oxygen sensor electrical connectors from bracket on transmission and disconnect them.
1 For Oxygen Sensor (O) 3 Behind Three Way Catalytic Converter (TWO) (G287)
2 For Oxygen Sensor (O) 4 Behind Three Way Catalytic Converter (TWO) (G288)
4 for Heated Oxygen Sensor (HO2S) 4 (G286) (in front of catalytic converter)
- Remove bolt - arrow - at left exhaust tract strap.
- Remove nuts - arrows -.
- Remove nuts in - 9 to 1 - sequence and remove left front exhaust manifold with catalytic converter.
- Remove nuts in - 6 to 1 - sequence and remove left rear exhaust manifold with catalytic converter.
Installing
Installation is in reverse order of removal, note the following:
• Replace gaskets and self-locking nuts.
• Secure all hose connections with hose clamps appropriate for the model.
• During installation, reinstall all heat insulation sleeves and heat shields at the same locations.
• During installation, all cable ties must be re-installed at the same location.
- Position the left rear exhaust manifold and catalytic converter on the cylinder head.
- Tighten the left rear exhaust manifold nuts in three steps in the specified tightening sequence:
- Position the left front exhaust manifold and catalytic converter on the cylinder head.
- Tighten the left front exhaust manifold nuts in three steps in the specified tightening sequence:
- Adjust the exhaust system so that it is free-of-tension after the engine is installed. Refer to => [ Exhaust System, Installing ] Exhaust System, Installing.
Tightening Specifications