Vehicle Electrical System Control Module 2, Removing and Installing

Vehicle Electrical System Control Module 2, Removing and Installing

Component location: Beneath central tube for instrument panel at bulkhead.

Removing

- If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided Functions".

- Select the function or path:





- Follow the instructions on the Vehicle Diagnosis Tester display.

- Switch off ignition and remove ignition key.

- Remove glove compartment.

- Press clip - 2 - aside - arrow - and pull Vehicle Electrical System Control Module 2 (J520) out of retaining frame.





- Disconnect electrical connector - 1 -.

Installing

Install in reverse order of removal, observing the following:

- Install glove compartment.