Storage Compartments, Version 1 with Non-Smoking Package
Storage Compartments, Version 1 with Non-Smoking Package
1 Center Section
2 Front Storage Compartment Cover
Removing
- Unclip front storage compartment cover - 2 -.
Installation
To install, perform the steps used in removal in reverse order.
3 Lining Mat
Removing
- Remove the Climatronic Control Module (J255) (A/C Control Head).
- Remove the cover from the front storage compartment - 2 -, if equipped.
- Unclip storage compartment trim - 7 -.
Manual transmission
- Remove cover with selector lever boot => [ Cover with Selector Lever Boot, Removing and
Installing ].
Automatic transmission
- Version I: remove the selector lever cover => [ Version I: Removing and Installing the Selector
Lever Cover ].
- Version II: remove the selector boot and cover => [ Version II: Removing and Installing the Selector
Lever Boot and Cover ].
All:
- Remove bolts - 4 - (quantity: 2).
- Remove omega clips - 5 -.
- Remove the left (or right) grab handle. Refer to => [ Left and Right Grab Handle ] Left and Right Grab Handle.
- Remove lining mat - 3 -.
Installation
To install, perform the steps used in removal in reverse order.
4 Screws
3.5 Nm
• Quantity: 2
5 Omega Clips
• Quantity: 2
• Maintain installation position as shown in illustration
6 Center Console
7 Storage Compartment Trim
Removing
- Remove the Climatronic Control Module (J255) (A/C Control Head).
- Remove the storage compartment trim - 7 -.
Installation
To install, perform the steps used in removal in reverse order.
8 Cover Light Lens
• clipped into storage compartment trim - 7 -
Cover with Selector Lever Boot, Removing and Installing
- Open ashtray in center console.
- Remove cover - 1 - with selector lever boot - 2 - upward.
To install, perform the steps used in removal in reverse order.
Version I: Removing and Installing the Selector Lever Cover
- Open ashtray in center console.
- Remove selector lever cover upward - arrows -.
To install, perform the steps used in removal in reverse order.
Version II: Removing and Installing the Selector Lever Boot and Cover
- Unclip selector lever boot - 1 - on both sides and remove upward - arrows -.
- Grasp through opening and remove cover - 1 - upward - arrows -.
- Disconnect electrical connector.
To install, perform the steps used in removal in reverse order.
Omega Clips, Installation Location
1. Omega clips