Shift Mechanism Cover Angled Bracket

Shift Mechanism Cover Angled Bracket

• The removal and installation of the shift mechanism cover angled bracket is shown on an automatic transmission shift mechanism in the illustration. The removal and installation of a shift mechanism cover angled bracket on a manual transmission shift mechanism is similar to that on an automatic transmission.

Removing

- Switch off all electrical consumers.

- Remove ignition key.

Manual Transmission

- Remove cover with selector lever boot => [ Cover with Selector Lever Boot, Removing And
Installing ] Shift Mechanism Cover and Securing Frame With Selector Lever Boot.

Automatic Transmission

- Version I: remove the selector lever cover => [ Version I: Removing and Installing the Selector
Lever Cover ] Shift Mechanism Cover and Securing Frame With Selector Lever Boot.

- Version II: remove the selector boot and cover => [ Version II: Removing and Installing the Selector
Lever Boot and Cover ] Shift Mechanism Cover and Securing Frame With Selector Lever Boot.

All:





- Remove center console. Refer to => [ Center Console ] Center Console.

- Remove tunnel sound absorption pad.

- Mark location of shift mechanism cover angled bracket - 2 - to center tunnel - 3 -.

- Remove nuts - 1 - (quantity: 4).

- Remove shift mechanism cover angled bracket - 2 - from center tunnel - 3 -.

Installation

Installation is reverse of removal, but note the following:

- When positioning shift mechanism cover angled bracket, note marking on center tunnel. Disregarding the installation location can lead to problems when installing the center console and attachments.

Tightening Specifications