Lumbar Support Adjustment Motor, Version 2

Lumbar Support Adjustment Motor, Version 2

Removing





• When replacing the lumbar support adjustment motor, the four-way lumbar support must not be at an end position.

- Remove backrest cover panel. Refer to => [ Backrest Cover ] Backrest Cover.

- Disconnect the connector - 1 -.

- Disengage retaining bracket - 2 - using a screwdriver and remove actuator - 3 - upward.

Installation

Installation is performed in reverse order of removal, noting the following:

• The lumbar support adjustment motor can be installed in one position only.