Operation CHARM: Car repair manuals for everyone.

Brake Lamp Switch on Brake Pedal






Brake Lamp Switch on Brake Pedal

The brake lamp switch is installed on the brake master cylinder, depending on the model. Refer to => [ Brake Lamp Switch on Master Brake Cylinder ] Brake Lamp Switch on Master Brake Cylinder

To ensure secure installation, switch may only be installed once.

Removing

- Remove the driver side storage tray.

- Separate the electrical connection.

- Remove the brake lamp switch by rotating it 45° toward the left.

Installing

Installation is in reverse order of removal, with special attention to the following:

- Pull out the plunger of the brake lamp switch completely - arrow -.






It may not be necessary to pull out the plunger depending on the version of the brake lamp switch.

- Insert the retaining tabs of the switch - 1 - and - 2 - into the intended notches in the installation opening and secure the switch by rotating it 45° toward the right.

- Connect brake lamp switch connector.

The brake pedal must not be actuated during installation.

When installing the brake lamp switch, the plunger adjusts itself automatically.

- Check the function of the brake lights by actuating and unactuating the brake pedal.