Module Carrier With Air Cushions For Lumbar Support

Module Carrier with Air Cushions for Lumbar Support

Removing






- Remove the backrest padding. Refer to => [ Bucket Seat Backrest Padding ] Bucket Seat Backrest Padding.

- Cut through cable tie - 3 -.

- Expose the wiring harness and pneumatic hose at retaining clip - 4 -.

- Carefully detach the adhesive of module carrier - 2 - from the backrest.

- Tilt the upper edge of the module carrier forward - arrow - and guide out at backrest adjustment shaft - 1 -.

- Remove the module carrier.

Installing

Install in reverse order of removal.

- Coat adhesive material on the reverse side of the module support. Adhesive material, refer to the Electronic Parts Catalog (ETKA)

Component assignment of the module carrier, refer to => [ Module Carrier with Air Cushions for Lumbar Support Component Assignment ] Module Carrier With Air Cushions For Lumbar Support Component Assignment.