Right Engine Mount

Right Engine Mount

• Only replace engine mounts in pairs of left and right.

• The retaining plates for them must also be replaced.

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

Removing

- Remove rear engine cover - top arrows -.





- Position Engine Support Bridge (10 - 222 A) on the left and right suspension strut tower as shown in the illustration.





- Engage the Spindle (10 - 222 A /11) on the right engine lifting eye and tension it slightly.

- Remove right front wheel.

- Remove right front wheel housing liner.

- Remove front noise insulation - 1 -.





- Remove nut - 1 - and remove the bracket with the wiring harness from the subframe.





- Remove bolts - 1, 2 and 4 - and move the right engine mount retaining plate - 3 - to the side.





- Vehicles with the multitronic transmission 0AW or automatic transmission 0B6: remove the bolt - arrow - on the ATF line bracket.





- Raise the engine by dimension - a - using the Spindle (10 - 222 A /11).





• Dimension - a - = Approximately 20 mm.

- Remove right engine mount.

Installing

• Tightening specifications. Refer to => [ Subframe Mount Assembly Overview ] Subframe Mount Assembly Overview.

Installation is in reverse order of removal, note the following:

- Install the wheel housing liner and noise insulation.

- Mount front wheel.