Right Flange Shaft

Right Flange Shaft

Special tools, testers and auxiliary items required

• Needle Bearing Drift (VW 295)

• Slide Hammer-Complete Set (VW 771)

• Retainer (3419)

• Oil Collecting and Extracting Device (V.A.G 1782)

• M10 nut, quantity: 2

Removing

- Remove the right front wheel.

- Remove the right drive axle cover - 1 - inside the wheel housing.






- Remove the bolts - arrows - and remove the heat shield from the right drive axle.






- Remove the right drive axle from the transmission flange shaft and move it back.

- Place the (V.A.G 1782) under the transmission.

- Install the threaded eye from the (3419) into the threaded hole in the right flange shaft with 2 M10 nuts - 1 -.






- Position the (VW 771) with the pulling hook (VW 771/13) on the threaded eye and remove the flange shaft.

Installing

Install in reverse order, paying attention to the following:

• Replace the circlip on the right flange shaft.

- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip - A -.






- Drive the right flange shaft in using the (VW 295).

- Install right drive axle.

- Install the drive axle heat shield => [ Driveshaft Heat Shield - Tightening Specification ] Transmission, Installing.

- Gear oil level in front final drive, checking and topping off. Refer to => [ Gear Oil Level in Front Final Drive, Checking and Filling ] Gear Oil Level In Front Final Drive, Checking and Filling.