Operation CHARM: Car repair manuals for everyone.

Window Regulator Motor







Window Regulator Motor

Removing

- Door trim removed.

The power window motor can be removed or installed with the motor or side window in any position.

Before removing motor, disconnect electrical harness connectors.

- Remove Torx screws - 2 - (T 30) and remove motor - 1 -.





Installation

- When installing, make sure that threaded pins - arrows - are engaged in inner door plate.

- Slide window regulator motor - 1 - onto threaded pin - 3 - and secure with screws - 2 -.

- Tightening specification 3.5 Nm

Only switch ignition on and off after installing motor and connecting wires.

Then move door window upward to stop and keep pressing switch for window regulator for approximately. 2 seconds longer.

This position is the base position and the high- and low-running function is activated.