Connectors, Disconnecting

Connectors, Disconnecting

CAUTION!
• Observe safety precautions for work on airbags.

• Before handling any airbag units (for example, when disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.





1 Front Seat

2 Belt Buckle Sensor Connector (Black)

3 Seat Heating Connector (Green)

4 Current Supply Connector (Red)

5 Airbag Connector (Yellow)

6 Panel or Cover

• for connector station

• Removing

- Tip front seat - 1 - back.

Vehicles without modular wiring routing through 07.2006

- Remove coupling station cover - 6 - upward.

Vehicles with modular wiring routing from 07.2006

- Remove connector station cover. Refer to => [ Modular Wire Routing with Corrugated Tube on Front Seat ] Modular Wire Routing with Corrugated Tube on Front Seat.

Procedure for all vehicles

- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.

- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.

- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.

- On vehicles with belt fastened detection: press the tab on the belt fastened detection connector - 2 - on the tunnel side in and remove the connector - 2 -.

- Connect airbag adapter. Refer to => [ Airbag Adapter, Connecting ] Airbag Adapter, Connecting.

• Installing

To install, perform the steps used in removal in reverse order.

Vehicles with a DVD player





- Push the grommet - 3 - to the side.

- Disconnect and free up the electrical connectors - 1 - and - 2 - and free up the wiring harness.