Headlamp Beam Adjustment Motors
Headlamp Beam Adjustment Motors
• Adjust the headlamps after performing any work that could have affected their adjustment.
CAUTION!
Danger to life due to high voltage.
Removing
- Remove headlamp, refer to => [ Headlamp, when Reusing Current Headlamp ] Headlamp, when Reusing Current Headlamp.
- Release securing guides - arrows - and remove headlamp housing cover.
- Remove bolts - arrows -.
- By pivoting adjustment motor - 1 - to the side, push ball head of adjustment axle out of ball head mount.
- Remove headlamp beam adjustment motor out of headlamp housing.
- Disconnect electrical connector - 2 -.
Installing
• Tightening specification, refer to => [ HID Headlamps Assembly Overview ] HID Headlamps Assembly Overview.
Install in reverse order of removal, observing the following:
- First, insert ball head of adjustment axle from the side into ball head mount of reflector, to do so pull reflector toward rear.
• Always adjust headlamps after removing, installing or replacing adjustment motors.
- Close the housing lid.
- Install the headlamp, refer to => [ Headlamp, when Reusing Current Headlamp ] Headlamp, when Reusing Current Headlamp.