Ignition Coil for Gas Discharge Lamp
Ignition Coil for Gas Discharge Lamp
• Adjust the headlamps after performing any work that could have affected their adjustment.
CAUTION!
Danger to life due to high voltage.
Removing
- Remove headlamp housings, refer to => [ Headlamp, when Reusing Current Headlamp ] Headlamp, when Reusing Current Headlamp.
- Release securing guides - arrows - and remove headlamp housing cover.
- If present, pivot securing clip - 1 - for electrical harness connector to side.
- Rotate ignition coil - 2 - for gas discharge lamp counter-clockwise - arrow -.
- Disconnect harness connector - 3 - at ignition coil for gas discharge lamp.
- Remove ignition coil for gas discharge lamp.
Installing
Install in reverse order of removal, observing the following:
• Harness connector must only be connected with ignition coil installed.
- Check if recess in housing of ignition coil for gas discharge lamp and recess in pressure ring align completely with each other - arrows -.
- Attach ignition coil for gas discharge lamp to headlamp and fasten clockwise until stop.
• Ignition coil must turn freely.
• Arrow on housing points upward.
- Connect harness connector.
- If installed, secure electrical harness connector using securing clip.
- Close the housing lid.
- Install the headlamp housing, refer to => [ Headlamp, when Reusing Current Headlamp ] Headlamp, when Reusing Current Headlamp.