Center Armrest With Pass-Through Cover Overview

Center Armrest with Pass-Through Cover Overview






1 2/3 Right Backrest

• With pass-through

• Vehicles with special equipment

2 Cover Frame

• Clipped into the rear seat backrest

• Removing and installing, refer to => [ Cover Frame ] Cover Frame

3 Hood

• For pass-through

• Removing and installing, refer to => [ Pass-Through Cover ] Pass-Through Cover

4 Lock Washers

• Quantity: 2

• For bolts - 6 -

5 Bracket

• Part of the center armrest and pass-through cover

• Is not removed individually

6 Screws

• Quantity: 2

• 8 Nm

7 Bolt

• Quantity: 4

• Self-Locking

• Always replace if removed

• 11 Nm

8 Internal Upholstery

• Removing and installing, refer to => [ Internal Padding ] Internal Padding

9 Center Armrest

• Removing and installing, refer to => [ Center Armrest ] Center Armrest

10 Trim

• For the cupholder

• Removing and installing, refer to => [ Cupholder Trim ] Cupholder Trim

11 Cupholder

• Removing and installing, refer to => [ Cupholder ] Cupholder

12 Key

13 Lock Cylinder

• For the pass-through cover

• Removing and installing, refer to => [ Pass-Through Cover Lock Cylinder ] Pass-Through Cover Lock Cylinder

• Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

• Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.

14 Protective Cap

• For lock cylinder

• Remove before installing the lock cylinder

The key must be inserted in the lock cylinder correctly before the protective cap is removed. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.