Fuel Tank With Attachments Overview

Fuel Tank with Attachments Overview






1 Nut

• 20 Nm

2 Mounting Strap

• Installed position: Locating point (hole) points in driving direction

3 Fuel Tank Heat Shield

4 Nut

• 20 Nm

5 Fuel Line

• To engine

• To disconnect, press release button on connection piece

6 Vent Line

• From the EVAP canister to Evaporative Emission (EVAP) canister purge regulator valve 1 (N80)

• Clipped in on fuel tank

7 Electrical Harness Connector

• For transfer fuel pump (G6) and fuel level sensor (G)

8 Protective Plate

• For fuel delivery connection

9 Bolt

• 11 Nm

10 Cover

• Attached to the fuel tank insert with a fastening device

11 Bolt

• 11 Nm

12 Ground (GND) Connection

• For discharging electrostatic charge

• Installed position, refer to => [ Fuel Filler Tube Ground Connection and Protective Plate ]

• Ensure connector is seated securely

• After installation, check electrical connection from fuel filler tube protective plate - 7 - to an empty place on the body using an Ohm meter; specified value: Approximately 0 ohms

13 Vent Line

• From gravity valve to EVAP canister

• Clipped in on bracket in wheel housing

• To disconnect, press release button on connection piece

14 Pop Rivet

15 Fuel Tank

• Removing and Installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank with Attachments

16 Nut

• 20 Nm

17 Lock Washer

• 3 Nm

• Turn toward left to remove

Fuel Filler Tube Ground Connection and Protective Plate





- Ensure filler tube threaded connections - 2 and 4 - are free of corrosion so the Ground (GND) connection to the body is not affected.

- Route GND connection - 1 - as shown in illustration.

- Ensure GND connection connector - arrows - is seated firmly on protective plate - 5 - and on filler tube - 3 -.

Risk of explosion due to electrostatic charge.

• After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.

• Specified value: Approximately 0 ohms.