Right Retaining Plate With Right Footwell Door Motor (V109) and Right Center Vent Motor (V111)

Right Retaining Plate with Right Footwell Door Motor (V109) and Right Center Vent Motor (V111)

- Removing the retaining plate with control motors. Refer to => [ Right Retaining Plate with Right Footwell Door Motor (V109) and Right Center Vent Motor (V111) ] Right Retaining Plate With Right Footwell Door Motor (V109) and Right Center Vent Motor (V111).

• The mounting plate with the Right Footwell Door Motor and the Right Center Vent Motor is installed only on vehicles equipped with the "Comfort" A/C system.

• Currently in this vehicle, all motors are identical in construction. During the basic setting, the control motors are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence does not conform the specification, the control motors will adapt incorrectly and the door control will be wrong. Refer to => [ A/C Control Motor Block Diagram ] A/C Control Motor Block Diagram.

• The control motor shaft does not have a stop; therefore the shaft of these control motors can be inserted into the cam plate in any position.

• Depending on the production date, there are different versions of the levers and connections on the A/C unit. Refer to => [ Air Conditioner, Levers and Connecting Elements ] Air Conditioner, Levers and Connecting Elements and the Electronic Parts Catalog (ETKA).






1 Screw

2 Right Center Vent Motor (V111)

3 Mounting Plate

4 Right Footwell Door Motor (V109)

5 Connecting Rod

• To the right center vent door

6 Connecting Rod

• To the right dash panel vent door

7 Actuating Lever

8 Connecting Rod

• To the right rear footwell vent door

9 Connecting Rod

• To the right front footwell vent door

10 Cam Disk

• On the Right Center Vent Motor (V111)

11 Actuating Lever

12 Actuating Lever

13 Cam Disk

• On the Right Footwell Door Motor (V109)

14 Cam Plate Stop