Servotronic Solenoid Valve (N119)

Servotronic Solenoid Valve (N119)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1332)

• Steering gear grease

Removing






Replacement is only possible when the steering gear is removed.

- Steering gear, removing; refer to => [ Hydraulic Power Steering Gear ] Hydraulic Power Steering Gear.

- Always clean steering gear - 6 - in servotronic solenoid valve - 3 - area.

- Make sure that no dirt enters steering gear - 6 -.

- Separate connector - 8 -.

- Make sure no dirt enters the connector - 8 -.

- Remove bolts - 1 and 2 -.

- Remove servotronic solenoid valve - 3 - from steering gear - 6 -.

- Remove screen - 7 - from steering gear - 6 -, clean steering gear if necessary.

Installing






Install in reverse order of removal. Note the following:

- Insert a new screen - 7 -.

- Lightly coat gasket - 4 and 5 - with steering gear grease and insert.

- Place servotronic solenoid valve - 3 - in steering gear - 6 - as far as stop. Do not tilt servotronic solenoid valve when doing so.

• Always follow bolt tightening sequence.

- Tighten screws - 1 - and - 2 - as follows:

1. Tighten bolt - 1 - to 0.5 Nm.

2. Tighten bolt - 2 - to 1.5 Nm.

3. Tighten bolt - 1 - to 3.0 Nm.

4. Tighten bolt - 2 - to 3.0 Nm.


- Steering gear, installing, refer to => [ Hydraulic Power Steering Gear ] Hydraulic Power Steering Gear.