Noise Insulation

Noise Insulation

Removing

- Turn off the ignition.

- Remove the shift lever knob with the shift lever boot. Refer to => [ Shift Knob with Shift Lever Boot ] Shift Knob With Shift Lever Boot.

- Remove the multimedia system control head (E380).






- Release the tabs - 1 - in direction of - arrow -. Raise the rear noise insulation when doing this.






- Pull the noise insulation off the tabs - 3 -.

- Pull the boot - 2 - off the gearshift lever in direction of - arrow -.

Installing






- Mount the noise insulation on the tabs - 1 - and then push down on it until the tabs - 2 - lock.

- Stretch the boot over the shift lever into the rounded groove - arrow A -.

- Press the support ring into the boot over the shift lever support in the direction of - arrow B - as far as the stop.

Install in reverse order of removal. Note the following:

- Install the multimedia system control head (E380).

- Install the shift lever knob with the shift lever boot. Refer to => [ Shift Knob with Shift Lever Boot ] Shift Knob With Shift Lever Boot.