Spray Nozzles, Adjusting

Spray Nozzles, Adjusting

Special tools, testers and auxiliary items required

• Windshield Washer Aiming Tool (T40187) equipped with Replacement Tip (3125/5A)

Adjusting






• The settings indicate the values for a moving vehicle, for example, the spray from the jets is slightly offset when the vehicle is stationary.

- Mark the six points on the windshield using a water soluble marker:













Risk of injury.

• If the (T40187) is not used, ensure that both sides are always covered and secured by covers - 3 and 4 -.

• If one side is not secured by the cover, injury can be caused by the (3125/5A) - 1 - or adjusting pin - 2 -.

• When opening each side, always ensure that the other side is not pointing toward the hand.

- Unlock the long cover - 1 - on the (T40187) - arrow A - and push it back - arrow B -.






- Place adjusting pin - 2 - on the respective nozzle - arrow - of nozzle unit - 1 - and aim at the points on the windshield and adjust if necessary.






- If the spray field does not correspond to the specifications, clean the dirty spray nozzle.

Risk of injury.

• The adjusting pin must be covered and secured by the cover after each use.

Cleaning the Nozzle

- Remove the nozzle. Refer to => [ Spray Nozzles ] Spray Nozzles.

- Flush the nozzle opposite to the spray direction using clear water.

- To remove any remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.

- If the spray field still does not match the specifications, replace the spray nozzle.