Front Bumper

Front Bumper

Special tools, testers and auxiliary items required

• Hose Clamps up to 25 mm diameter. (3094)

• Socket (T40078)






1 Bumper

• On vehicles with headlamp washer system, hose line from washer fluid reservoir must be clamped off using a (3094).

• Removing

- Unclip covers - 2 - and - 9 -

- Remove bolts - 3 -;- 4 -;- 5 - and - 6 -.

- Loosen wheel housing liner in nut area - 10 - and pull back => [ Removing ] Inner Wheel Housing Liner.

- Remove zero gap connection nuts - 10 -.

- Remove the lower screws from the noise insulation in the bumper area.

- Unclip bumper sideways from guide pieces and pull forward slightly.

- Remove electrical wire to fog lamp, clamp off line to headlamp washer system if necessary.

- Bumper completely from vehicle

• Installing:

- Use markings on radiator grille - arrow - for exact adjustment lengthwise.

- When installing, tighten upper bolts on bumper in - 3 -;- 4 -;- 5 - and - 6 - sequence.

2 Right cover

• Unclip

3 Bolt

• 5 Nm

4 Bolt

• 5 Nm

5 Bolt

• 5 Nm

6 Bolt

• 5 Nm

7 End plate

• No replacement part

• Slide into support - 8 - on lock carrier as shown.

8 Carrier piece

• No replacement part

• Part of lock carrier delivery package.

9 Left cover

• Unclip

10 Nut

• Use (T40078) to loosen or tighten nut.

• 6.5 Nm