Tunnel Side Trim

Tunnel Side Trim

• The tunnel side trim panel can only be removed and installed when the front seat removed.

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the front seat:

• Manual seat, refer to => [ Front Seat ] Front Seat.

• Power seat, refer to => [ Front Seat ] Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Installing Front Seat On VAS 6136 ] Installing Front Seat on VAS 6136.

- Remove expanding rivets - 1 - (quantity: 2).






2 Tunnel side trim

- Remove the seat belt latch - 3 -. Refer to => [ Front Belt Latch Anchorage Point ] Front Belt Latch Anchorage Point.






- Remove the bolt - 2 -.

- Remove tunnel side trim panel - 1 - upward.

Installation

Install in reverse order of removal. Note the following:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

- Switch on ignition.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect battery ground cable with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

For the correct tightening specifications, refer to => [ Sill and Tunnel Side Trim Assembly Overview ] Sill and Tunnel Side Trim Assembly Overview