Air Filter Housing

Air Filter Housing

Removing

- Remove air filter element. Refer to => [ Air Filter ] Service and Repair.

- Remove bolts - arrows - and remove air duct.





- Remove lower section of air filter housing - arrows -.





Installing

Installation is in reverse order of removal, note the following.

• Air filter housing must always be clean.

• Secure all hose connections with hose clamps appropriate for the model.

• Note the following when blowing out air filter housing with compressed air: To prevent malfunctions, cover critical air-flow engine components such as Mass Air Flow sensor, air duct pipes etc. with a clean cloth.

- Blow out water drain (small hole in lower section of air filter housing) with compressed air.





- Clean air filter housing (upper and lower sections) of salt residue, dirt or leaves (use vacuum cleaner if necessary).

- Check Mass Air Flow sensor and air duct hose (clean air side) for salt residue, dirt and leaves.

- Check the air duct from lock carrier to air filter housing for dirt and leaves.

- Place upper section of air filter housing on to lower section or air filter housing carefully and without using excessive force. When doing this, make sure that upper section of air filter housing is not placed tilted on the air filter element (pay attention to sealing lip of air filter element).

• Tightening Specifications. Refer to => [ Air Filter Assembly Overview ] Engine Code CDMA.